How to fit
1)Identify the front and rear of your crampons; the rear is signed by the inscription “BACK“. Lead the elastic through the front of the shoe, making sure, that the spikes of the spiked plate are pointing outwards and not towards the sole of the shoe. There is no difference between the left and right crampon.
2 VERY IMPORTANT! )The front part of the micro-crampon´s tread may get stuck in the tread of the shoe. In this case they must be carefully accompanied towards the middle of the shoe (drawing 2) so that the front part of the micro crampon is correctly fitted.
3) Grab the back of the coloured elastomer with both hands and carefully pull towards the heel so that the micro crampon is fully fitted. It is important to check that there are no connecting parts between the elastomer and the tread on the edge of the sole (danger of breakage).
4+5) Complete the fit by pulling the back of the elastomer upwards so that it is at least 1 cm above the edge of the shoe. If this does not happen, the size of the micro crampon may not be the correct one. If the micro crampon has been fitted correctly, all parts of the tread will be correctly tensioned. To remove the micro crampon, perform the fitting steps in reverse.
HOW TO FIT – HE HAS TO KNOW
Marco De Gasperi – Skyrunning World Champion 2017 – was instrumentally involved in the development of TRAIL and uses the NORTEC MICRO CRAMPONS for his training and in races. In this two video he shows how to put on TRAIL and NORDIC.
INSTRUCTIONS FOR USE
The device, used in normal conditions and with a normal frequency, has a useful life of three years of utilization. Before every use of the crampons, control visually, that the product isn‘t damaged and the functuality is given (all metal and the other parts need to be intact and free of cracks); if you see any damage on the metalparts or the elastomer, it is necessary to substitute the product. Before every use of the crampons, make sure you wear them properly and do a test to verify the effectiveness in relation to grounds you want to walk on. The crampons are used to walk on ice, snow, wet meadows, soft, muddy and slippery grounds. They are not used to walk on hard, rocky, or stone covered ground, due to the fact, that on these surfaces the danger of slipping is given. Immediately remove the crampons, when the ground on which you are walking on, is no longer slippery. Do not use crampons on delicate surfaces (parquet, wood, carpets, etc.). Don‘t use this product while driving your car. Don‘t use this product during extreme activities. Put the shoe chains always in the foreseen transport bag; always be aware that the spikes do not point in body direction during transport (injury hazard).
After use, the product should be washed in warm water with mild soap and must be dried before being placed in his custody. After use, store your crampons in a dry and ventilated place, away from heat and direct funds of sunlight.
LIMITS OF USE
The product mustn‘t be used for climbing; The product mustn‘t be used on inclines exceeding 20%; The use of the product must be evaluated by the user which is totally responsible for his actions and for any damage resulting from improper use of the product.
The product is guaranteed for any defects due to the materials used and their assembly. Excluded from the guarantee are: normal usury, not suitable maintenance, improper use, repairs, modifications or alterations made without the written permission of the manufacturer. This warranty does not apply any other rights than those mentioned. The manufacturer declines all liabilities concerning the direct, indirect or accidental consequences, including any consequence that derives from the incorrect use of the devices, including correct use of the device in unsuitable situations that do not ensure proper safety levels. Warning! Do not use a device for activities that exceed its limitations or for uses that are different to those intended! Each individual is responsible for his/her own choices and actions: anyone who is not capable of assuming this responsibility must not use these devices under any circumstances. The responsibility of the manufacturer is limited defectiveness related to manufacturing and the materials used.
Equipping oneself with individual protection devices does not justify exposing oneself to risks that are potentially lethal.